hm. I am not a pro.
But it might depend on what you defined in the
"HAL-section" in your machine.ini file:
Code:
[HAL]
HALUI = halui
HALFILE = BridgeportCNC-1.hal
HALFILE = custom.hal
HALFILE = vc-p4s.hal
POSTGUI_HALFILE = postgui_call_list.hal
POSTGUI_HALFILE = vc-postgui.hal
SHUTDOWN = shutdown.hal
look, what is written in your
"postgui_call_list.hal"-file. Mine looks like this and it works:
Code:
# These files are loaded post GUI, in the order they appear
source custom_postgui.hal
what ever file you are loading at start up, it should contain the code below.
my
postgui.hal is empty. but the
custom_postgui.hal should look like the following:
Code:
[code][code]# The next lines are only needed if the pins had been connected before
unlinkp iocontrol.0.tool-change
unlinkp iocontrol.0.tool-changed
unlinkp iocontrol.0.tool-prep-number
unlinkp iocontrol.0.tool-prepared
# link to gmoccapy toolchange, so you get the advantage of tool description on change dialog
net tool-change gmoccapy.toolchange-change <= iocontrol.0.tool-change
net tool-changed gmoccapy.toolchange-changed <= iocontrol.0.tool-changed
net tool-prep-number gmoccapy.toolchange-number <= iocontrol.0.tool-prep-number
net tool-prep-loop iocontrol.0.tool-prepare <= iocontrol.0.tool-prepared
[/code]
[/code]
good luck! once it's working, it's a dream! It's worth the effort to fix it!
