HAL and INI files for Dual Y Axis, HY VFD

I am migrating to a dual Y axis setup (from a single) and need some help. My setup is basically:

• LinuxCNC 2.9
• Parallel port BOB
• 4x stepper drivers (currently, I have two drivers connected to the same Y step+dir signals, but will move these to each of the Y signals are separate)
• Proximity sensors for homing (but not for limit checking on each extreme)
• HY VFD connected via RS-485

Can anyone please share their HAL and INI files with me for their similar setup?

Thanks!
 

This is for PlasmaC so has a lot of other stuff you might not need, but the homing stuff is with shared switches to save on inputs.

Thanks, Tommy! I took a quick look and I think the configs make sense for what I have. I'll give it a shot.

Tommy, thanks again. Using your HAL and INI file I was able see what changes I needed to make and it's working great! Dual-Y axis with "self squaring" homing!

You are welcomed, always.