Forum Header

Mach 3 conversion to Stepconf Wizard

More
10 years 10 months ago #66203 by LinuksGuru
Replied by LinuksGuru on topic Mach 3 conversion to Stepconf Wizard
Hi, John,

Is it possible to convert with this script Mach3 setup with 2 motors for driving X axis into the LinuxCNC gantry?
Or this have to be done manually?
The topic has been locked.
More
10 years 10 months ago #66278 by BigJohnT
Replied by BigJohnT on topic Mach 3 conversion to Stepconf Wizard
Give it a try and see... but I would assume you will need to start with typical configuration then add the extra motor.

JT
The topic has been locked.
More
10 years 8 months ago #70112 by scalci
Replied by scalci on topic Mach 3 conversion to Stepconf Wizard
Hi, BigJohn

Can you please assist me wig my xml file?

Rgs
Scalci
The topic has been locked.
More
10 years 8 months ago #70518 by andypugh
Replied by andypugh on topic Mach 3 conversion to Stepconf Wizard
The Stepconf wizard now contains the XML import facility.
The topic has been locked.
Time to create page: 0.039 seconds
Powered by Kunena Forum