Forum Header

5 axis baord screenshots of stepconf for it please?

More
6 years 5 months ago #166848 by gzcwnk
5 axis baord screenshots of stepconf for it please? was created by gzcwnk
Hi, this is apparently a common BoB used in LinuxCNC does anyone have the config shots for stepconf please? I have tried a few times but am unable to make it go.

Please Log in to join the conversation.

More
6 years 5 months ago #166868 by andypugh
Replied by andypugh on topic 5 axis baord screenshots of stepconf for it please?
Use a step time of 5000nS.

If that doesn't help, try inverting the step pulse in stepconf.

Please Log in to join the conversation.

Time to create page: 0.169 seconds
Powered by Kunena Forum