I have this other BoB 5 axis board also screenshots of stepconf for it please?

1 is the enable all, this would be EM stop out? would it be inverted?

Hi
Welcome
FOR the First setup you shoudt leave the ENA+ and ENA- of your Drive for testing unconnected
then as the machine moves in real AXIS/Gmoccapy
open up the config again and connect the ENA+ ENA-

then on F1 Keybord hit or Machine ON Button you see if it goes on or off

Best practice

What Drives are you using on this board

gzcwnk wrote: 1 is the enable all, this would be EM stop out? would it be inverted?

It should be "machine.is.enabled" not e-stop, and yes it can be inverted in hal.