Forum Header

Motors wont move

More
5 years 2 months ago #218406 by Schneiderman
Motors wont move was created by Schneiderman
 HI guys!

I am new to LinuxCnc,

I am having some problems with StepConf Wizard. When i try to test the axis, the motors does not move at all.

I already checked all the wires and apparently every thing is fine.

Some body could give me a light on this issue?

Thank you all in advance!

Please Log in to join the conversation.

More
5 years 2 months ago #218407 by phillc54
Replied by phillc54 on topic Motors wont move
This thread may be helpful.
forum.linuxcnc.org/16-stepconf-wizard/43...3-x3-no-mvmnt#218391

Please Log in to join the conversation.

More
5 years 2 months ago #218415 by tommylight
Replied by tommylight on topic Motors wont move
Pretty sure i read the same post earlier today that got deleted or moved ....

Please Log in to join the conversation.

More
5 years 2 months ago #218510 by Schneiderman
Replied by Schneiderman on topic Motors wont move
Thank you for your answer!

Linux wasnt recognizing the paralel port that i had installed, now everything is working fine!

Thank you for your help!

Please Log in to join the conversation.

More
5 years 2 months ago #218511 by Schneiderman
Replied by Schneiderman on topic Motors wont move
Hi tommy,

I already resolved fixed the issue,

Linux wasnt recognizing the paralel port that i had installed, now everything is working fine!

Thank you for your help!

Please Log in to join the conversation.

Time to create page: 0.090 seconds
Powered by Kunena Forum