Remora - ethernet NVEM / EC300 / EC500 cnc board

By the way, ST-Link v2 can be converted to the J-Link OB. By uploading J-Link firmware. Just google it

I thought that broke Segger's license agreement.

scotta wrote:

I thought that broke Segger's license agreement.

I think Novusun also "isn't happy" when we reflashing their devices  

And loads of flux it's pain they went with this style of chip. Harder to solder but once you have hot air and stencils it's do able. Do you have a microscope? I use a cheap Chinese one and does the job fine

Murphy wrote:

And loads of flux it's pain they went with this style of chip. Harder to solder but once you have hot air and stencils it's do able. Do you have a microscope? I use a cheap Chinese one and does the job fine

I borrowed a set of magnifying glasses. Should do the job. I'm thinking this will be the surest way as I've started to trace out using Rog's photos and cross referencing to the MCUExprsso config tool. But what appears to be a UART pin does not go to a UART enabled pad...? A close up of the tracks at the rear of the MCU would be super helpful.

 

Here you go Scott, if you need higher resolution I can steal my wife's iPhone

Hi Rog, something happened with the file / picture. It's not showing up.

Rog's post forum.linuxcnc.org/18-computer/44828-rem...ard?start=420#251712 pic looks fine here

I get "The requested content cannot be loaded. Please try again later"..?

imgur.com/a/wrr00rm a copy is here.