Using skr 1.4 turbo with w5500 for Linuxcnc

2 years 2 weeks ago #312052 by 3dtech_ks

Using skr 1.4 turbo with w5500 for Linuxcnc was created by 3dtech_ks

Hello , can someone please share the config file for skr 1.4 turbo with w5500 module for linux cnc use

Please Log in to join the conversation.

2 years 2 weeks ago #312060 by tommylight

Replied by tommylight on topic Using skr 1.4 turbo with w5500 for Linuxcnc

Please Log in to join the conversation.

2 years 2 weeks ago #312070 by 3dtech_ks

Replied by 3dtech_ks on topic Using skr 1.4 turbo with w5500 for Linuxcnc

Im not sure yet, i know skr 1.4 uses LPC1768 , SKR 1.4 TURBO uses LPC1769 , but can i use the same config.txt for both ?

Please Log in to join the conversation.

2 years 2 weeks ago #312075 by tommylight

Replied by tommylight on topic Using skr 1.4 turbo with w5500 for Linuxcnc

The only difference between LPC1768 and LPC1769 is the working frequency, so everything should work for both, see last post on the link.
community.nxp.com/t5/LPCXpresso-IDE/LPC1...ferences/td-p/578600

Please Log in to join the conversation.

1 year 11 months ago #314127 by tommylight

Replied by tommylight on topic Using skr 1.4 turbo with w5500 for Linuxcnc

Now we have control of TMC drives through UART, apparently:
forum.linuxcnc.org/show-your-stuff/50177...ny-solder-bot#314119

Please Log in to join the conversation.

Time to create page: 0.086 seconds