probe m6

More
14 years 3 weeks ago #24951 by billykid
probe m6 was created by billykid
Some years ago I was able to do the manual tool change with probe height.
this by inserting a sub after M6.
I was wondering if it was possible only with the command M6
regards
Mauro

Please Log in to join the conversation.

More
14 years 3 weeks ago #24952 by skunkworks
Replied by skunkworks on topic Re:probe m6
Might give this a this a look..

linuxcnc.org/docs/devel/html/remap/structure.html

I think it is only in the development version..

sam

Please Log in to join the conversation.

More
14 years 3 weeks ago #24953 by BigJohnT
Replied by BigJohnT on topic Re:probe m6
IIRC you can configure that in master.

John

Please Log in to join the conversation.

More
14 years 3 weeks ago #24954 by billykid
Replied by billykid on topic Re:probe m6
thanks !
wait for the release 2.6 :-)
Mauro

Please Log in to join the conversation.

More
14 years 3 weeks ago #24955 by BigJohnT
Replied by BigJohnT on topic Re:probe m6
That might be a long time 2.5 just came out... If you like you can checkout master and use a RIP to test it out. Full instructions are on the wiki page

wiki.linuxcnc.org/cgi-bin/wiki.pl?Installing_LinuxCNC

John

Please Log in to join the conversation.

More
14 years 3 weeks ago #24958 by billykid
Replied by billykid on topic Re:probe m6
ok i will try
thanks
Mauro

Please Log in to join the conversation.

More
14 years 3 weeks ago #25013 by billykid
Replied by billykid on topic Re:probe m6
Hi John do you like my bike? year 1982 xt550j yamaha :-)
Mauro

Please Log in to join the conversation.

More
14 years 3 weeks ago #25015 by BigJohnT
Replied by BigJohnT on topic Re:probe m6
It looks in better shape than my 1984 Honda XL200R

600


John

Please Log in to join the conversation.

More
14 years 3 weeks ago #25019 by billykid
Replied by billykid on topic Re:probe m6
very nice even your little honda John :-)

Mauro

Please Log in to join the conversation.

More
14 years 3 weeks ago #25111 by andypugh
Replied by andypugh on topic Re:probe m6
BigJohnT wrote:

That might be a long time 2.5 just came out... If you like you can checkout master and use a RIP to test it out. Full instructions are on the wiki page

wiki.linuxcnc.org/cgi-bin/wiki.pl?Installing_LinuxCNC


Wouldn't it be easier to grab 2.6 from the buildbot?

(Harder to revert, though)

Please Log in to join the conversation.

Time to create page: 0.323 seconds
Powered by Kunena Forum