Change Tool Cone Size in Axis

Pushed to 2.8 and master - a few hours to get through the buildbot
under the [DISPLAY] heading:

CONE_BASESIZE = .25

numbers 2 - .025

Chris

cmorley wrote: Pushed to 2.8 and master - a few hours to get through the buildbot
under the [DISPLAY] heading:

CONE_BASESIZE = .25

numbers 2 - .025

Chris

Chris, great thanks! I love it when ideas discussed on the forum become features in LInuxcnc. Its just the power of open source at work!

I'm due to rebuild my Plasmac config, so I'll give it a whirl in the next couple of days.

That works a treat Chris, thanks.

Thanks for pushing the PyVCP stuff as well.

It's like we are all a team!
Love it when a plan comes together...

Glad I could help.... hahahahaha

Thanks Chris

Is this also pushed up into Master?
if not, could you please...
Thanks.

It's in master.

I have been trying to adjust the cone size in plasmac but this setting seems to have no effect. Do you know if plasmac overrides this config somewhere?

rducky5 wrote:

I have been trying to adjust the cone size in plasmac but this setting seems to have no effect. Do you know if plasmac overrides this config somewhere?

 

Have you seen this:- forum.linuxcnc.org/21-axis/38485-change-...axis?start=10#159119

Yes, I did see that setting and it seems to be working with axis but does not have an impact when using gmoccapy. I even found the code in glcannon.py but hard coding that doesn't have an impact