2.9 axis with 1366x768

Hi all. I decided to switch to 2.9 and after installing it I ran into a problem that the axis does not fit into the 1366x768 resolution in height. Are there any solutions for this or will it be necessary to edit the axis source?

Try this: forum.linuxcnc.org/gmoccapy/49591-displa...tly-too-big?start=10

to fix this, you need to replace the divisor for "dpi_value" in the /usr/bin/axis file on line 125. the default was 72. replaced by 75 now the axis of norms expands to full screen:
root_window.tk.call('tk', 'scaling', '-displayof', '.', dpi_value / 75)

Do you only have a problem with axis? Gmoccapy is displayed correctly?

besriworld wrote:

Do you only have a problem with axis? Gmoccapy is displayed correctly?

yes gmoccapi has the same problem but i don't use it

no screen (currently supported) will fit that height resolution if you have the windows bar thing.

I have 2 solutions for right now, and I will toss up another simple one later

This is my current WIP one, with many customize options. it will fit. I use it with 800x480 and 1024x768. Im sorry if some stuff doesnt translate, I dont know how it will act with translations
www.forum.linuxcnc.org/21-axis/49372-reg...od-based-on-plasmac2

This is the first one I made, it fits 800x480. It might make the text a bit small for you
www.forum.linuxcnc.org/21-axis/38188-sol...screen-w-usercommand

I think if you remove the max velocity slider and the active gcode label, it will fit. I can try to whip that up after work. I suggest trying out the first one though.

daiman444 wrote:

to fix this, you need to replace the divisor for "dpi_value" in the /usr/bin/axis file on line 125. the default was 72. replaced by 75 now the axis of norms expands to full screen:
root_window.tk.call('tk', 'scaling', '-displayof', '.', dpi_value / 75)

this decision and for today during testing there were no side effects.

for gmoccapi, everything turned out to be much simpler. you need to save a copy of the file "/usr/share/gmoccapy/gmoccapy.glade" and edit it in a text editor as follows:
<object class="GtkWindow" id="window1"> needs to decrease requested height
<property name="height_request">735</property>
do editing the file "gmoccapy.glade" only in a text editor!!!

Is this the same problem as has been described in this thread?:
www.forum.linuxcnc.org/gmoccapy/49591-di...tly-too-big?start=10

If so then it seems to be an issue with the X11 window manager.

Yes, in that topic the same problem with a window height of 768 pixels. i suggested there solution for gmoccapy

the reason axis is bigger in 2.9 is not a bug. There was an update, which moved the active gcode list to be always shown. gcodes and gcodel were moved from MDI tab to pane.top . It is a good update, but this made the window bigger by 3 text heights.

github.com/LinuxCNC/linuxcnc/commit/74d4...946bb56465a141b1ff99