Ignore Limit check Box Missing

Project_Hopeless
Topic Author
Offline
Elite Member

2 years 2 weeks ago #311839 by Project_Hopeless

Ignore Limit check Box Missing was created by Project_Hopeless

I'm running LinuxCNC 2.9 with a Axis GUI and Switchkins motion (6 DOF robot). I notice the "ignore limits" check box is missing entirely.

Is this a setting in the ini file that needs to be set that I missed?

Please Log in to join the conversation.

Aciera
Offline
Administrator

2 years 2 weeks ago #311849 by Aciera

Replied by Aciera on topic Ignore Limit check Box Missing

Maybe this helps:
forum.linuxcnc.org/21-axis/49044-axis-ov...limits-checkbox-gone

Please Log in to join the conversation.

Project_Hopeless
Topic Author
Offline
Elite Member

2 years 2 weeks ago #311885 by Project_Hopeless

Replied by Project_Hopeless on topic Ignore Limit check Box Missing

Aciera wrote:
Maybe this helps:
forum.linuxcnc.org/21-axis/49044-axis-ov...limits-checkbox-gone

That was it. I needed at least 1 axis limit setup in the io.hal.

Please Log in to join the conversation.

Time to create page: 0.439 seconds