Huanyang vfd Plug-in

behold,
below you will find all my configuration files for both " test" suggested by " pommen " and " test2 " suggested by " vre " .

thank you again very much to all

I told you when you run stepconf wizard to not check/use any spindle function/pin
1) run stepconf wizard without sellection of any spindle pin (config without spindle) and without pyvcp panel
2) follow the instructions for huanyang AFTER you run stepconf wizard

ok i rerun step by step everything you've told me inserting new files you sent me .

but ccomunque error

./custom.hal:7 : waitpid failed hy_vfd spindle- vfd
./custom.hal:7 : hy_vfd exited without becoming ready


I have two questions arise spontaneously , I have to install any special drivers for r485 stick?

The VFD must be attached and turned on when throwing test2 or should function independently ?

1)no
2)no

run:

FANTASTIC !!!!! I tried to restart test2 after inserting my USB and finalmnete the part program !!!!! and also I see the spindle controls !!!!!

Now I just have to try to connect the VFD and see if it really works !!!

thanks a lot to everyone !!!

will let you know soon!