is there driver for the new XHC-WHB04B-4

okay that's no problem thank you!

Hi all,

Im working on driver for WHB04B-6 but I belive it will work with WHB04B-4 too,

here is the code:
github.com/smalla/linuxcnc

the MPG is working,
now Im working on the display section, as it is way too different from xhc-hb04

suggestions are always welcome

Can You please try it if it works with the whb04b-4 ? it would be nice to know.

thanks

smalla,

I have a WHB04B-4, and I am in the process of setting up a new LinuxCNC system.

PC is built, LinuxCNC installed. (downloaded from linuxcnc.org today)

I have used the Config-picker to select the xhc-hb04 to select the layout1 demo. It pops up the "exited without becoming ready" error.

This may very well be an error between my keyboard and my chair, I'll keep digging into it looking for obvious stuff.

If there is any thing you would like me to look at, let me know.

Thanks!

Edit:
Installed lsusb, the dongle shows up as Silicon Labs, ID: 10cd:eb93

Can you paste the output that results from running LinuxCNC from the command line?
(command "linuxcnc")

Hi, the XHC-HB04 and the XHC-WHB04B-4(6) are different devices in terms of encoding the signal.
I have made a driver for the XHC-WHB04B-6, as I have this device, but Im pretty sure it will work with the whb04b-4.
Maybe de usb device identifier needs to be replaced.
it can be found here in this fork:
github.com/smalla/linuxcnc

It only works for linuxcnc 2.8 series as configured to use joints and axes. I havent pushed it to the mainline yet, as it still has some bugs, mainly with the display:
The 4th line of the display is not reachable, its quite impossible to display all the stuff needed.
It can be used to drive the axes, but the display is lagging behind the actual position, I couldnt figure out why, and where the data is leaking, why the screen is not updated.

I can help You to install this driver, its not too complicated.

smalla, that would be great!

In exchange I could help troubleshoot/debug the "-4" version.
I have programming experience but would probably be most effective to the effort as a guinea pig/tester.

I have to go out and run some errands, but let me know how I can support.

Download, install and try

let me know the problems.

Have You ever installed linuxcnc from source? Than it wont be hard.

Can I pull your branch from Git and install on top of the existing 2.7?

Following this guide: linuxcnc.org/docs/devel/html/code/building-linuxcnc.html
At "1.1" just replace the Git address with your branch.

it wont work with 2.7 unless you rewrite the .tcl file
because of joints and axes introduced in 2.8.