is there driver for the new XHC-WHB04B-4

Thank you @smalla,

my problem is that somehow I am stuck at 2.7.14 (the latest iso image). Somehow it won't update / upgrade via apt-get. I have no idea how to update to LinuxCNC v2.8. I would really like to do so because I like the layout of the new XHC-WHB04B-4 even better than the older model. Can you point me to the right direction how to perfom the update to 2.8? Thanks!!

Best regards
Thomas

If you are on Ubuntu you can use my nighty builds of 2.8.

launchpad.net/~szechyjs/+archive/ubuntu/linuxcnc-daily

Hello, please describe how to run MPG
XHC-WHB04B-4 USB cable.
Step by step .

Hello, I'm also on 2.7.14 and would like to configure the driver for this wireless pendant. Unfortunately reading this thread i was unable to locate any files necessary.

smalla wrote: My code should work with the WHB04B-4 with some USB ID changes in the code, but only with LinuCNC v 2.8.

Smalla, can you provide the the code for XHC-WHB04B as an attachment here on the forums? I was unable to find it in your github project. Thanks in advance!

Cheers,
Bushman

Hello, I started XHC-WHB04B-4 I tested working but I had to install Linuxcnc 2.9 on Debian 7
Gives the link and my poor quality video

www.cnc.info.pl/mpg-linuxcnc-2-9-usb-cnc...dant-t103332-60.html
www.machmaker.pl/1_10_5_instrukcja-insta...stemie-debian-7.html


Now I have a problem how to set the huanyang spindle control via RS-485 in Linuxcnc 2.9 and that's because I don't know how to mark in the configuration card that has changed take it.



I had running spindle control according to this guide on Linuxcnc 2.7.14 and it was OK

This is my mistake with Huanyang RS-485.
Debug file information:
./custom.hal:8: Pin 'motion.spindle-forward' does not exist

custom.hal
loadusr -Wn vfd hy_vfd -n vfd -d /dev/ttyUSB0 -p none -r 9600

net spindle-cmd-rpm-abs => vfd.speed-command
net spindle-cw motion.spindle-forward => vfd.spindle-forward
net spindle-ccw motion.spindle-reverse => vfd.spindle-reverse
net on motion.spindle-on => vfd.spindle-on



custom_postgui.hal
net spindle-cmd-rpm-abs => pyvcp.spindle-speed

net spindle-at-speed => pyvcp.spindle-at-speed-led
net spindle-at-speed => vfd.spindle-at-speed


setp vfd.enable 1