Parameters to classicladder possible?

the component i load with "loadusr python python/z_rotation.py" because i have a seperate python folder in my config to make it a little more clean. Also the loading is right on the top of the hal file where the other "loadrt" are.

the pin connection is in my main hal file:

net classicladder_rotation_z_float classicladder.0.floatin-01 <= z_rotation.z-rotated-angle


when i add -Wn i get an error (uploaded a pic)

i tried giving read and write permissions for everyone for this python script but still the same

You have to give read permissions to the folder also.

comment out the signals and see if the component loads.

Please post your config file so I can see what's going on.
It maybe a few hours till I get back to this

You have to give read permissions to the folder also.

did that, still the same: permission denied

when i comment out the pin "z_rotation.z-rotated-angle" and delete -WN from loadrt linuxcnc starts.


the component is working, i made some screenshots. Also i uploaded my config folder

thanks for helping me

you have:
loadusr -Wn python python/z_rotation.py

try:
loadusr -Wn z_rotation python python/rotation.py

Chris

THANK you its finally working

Glad we got it - post a pic of your screen with the indicator - I'd like to see what you've done

Chris

its currently on the bottom right under "WZW Kegelreinigung"

everything is still a mess, someday it will be pretty

and yes, on the Heidenhain controller the icon is also small (i made screenshots from the Windows simulator software). Maybe i will create bigger ones

btw i went and used the "is-rotated" bit pin because classicladder seems to round up the float number