Huyndai hit 15s retrofit

Any idea if theres a visual differance between the 2?

Got some more pics , 611 part number come back to universal so i think were good there.

       

Wires:
P24 = +24V from other source used for signaling
+24V = what it says, not the same as above, should not be wired together or mixed.
SRDY = servo ready
XFLT = X fault
0VG2 = 0V ground, goes with +24V, not with P24
ZFLT = Z fault
-
no more

It does seem that you have the analog version. in this pic below, terminals 56 and 14 are the analog +-10v command.
Im having trouble finding the siemens manual for your specific part numbers

***edit....pasting the pic doesnt seem to work
 

I have the manual in pdf but its a pain to decipher it lol

Ovg2 is cvg2, that and cvs2 are the -+10v

X311 is the encoder but i think its t tapped to the other plug on the encoder card

The 2 +24v are +24v to pluse enable
Sce1 and 2 are controller enable

P24 says speed controller at its end stop, whatever that means lol

I tried to post this before but the fourm is stupid sometimes

Next dumb question

what are these? I gues i could take one off lol 

Also im thinking of selling some parts i dont need like the old cpu cards and stuff, just wanna make sure i dont need n e of this

 

I still need to find what all the factory i/o stuff was connected to the the po helped himself too, this machine has a huge relay board im assuming most goes there. Also im gunna need to figure out the encoder stuff and get some connections to the mesa io

Panel is donish, waiting for my ne keyboad so i can make brackets

 

Came out decent for a hand drill and a grinder lol

Got my keyboard fellas, got to go outta state this week, more to come soon. Happy new years everyone.

Heu guys i used my laptop and installed linuxcnc on my ssd from a usb and it seems it wont boot, i just get a black screen with a white prompt. Did i do sumin wrong? Mabe a bios problem?