Mesa 7i96 driver/setup Plasma Table

Okay, I fixed the problem; thanks Rodw!

Added the config that should work with 7i96.
forum.linuxcnc.org/plasma-laser/34978-th...-with-how-to?start=0

hi I have the same problem with the mesa 7i96

eth1: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP group default qlen 1000
link/ether 78:d0:04:21:ce:e3 brd ff:ff:ff:ff:ff:ff
inet 10.10.10.1/24 brd 10.10.1.255 scope global eth1
valid_lft forever preferred_lft forever
inet 10.10.10.10/24 brd 10.10.10.255 scope global secondary eth1
valid_lft forever preferred_lft forever
inet6 fe80::7ad0:4ff:fe21:cee3/64 scope link
valid_lft forever preferred_lft forever

Linux Cortadora2 4.9.0-8-rt-686-pae #1 SMP PREEMPT RT Debian 4.9.110-3+deb9u6 (2018-10-08) i686 GNU/Linux


any idea?

You host MAC is misconfigured
It seems you have an aliased IP address that matches the 7I96 (10.10.10.10)
this will prevent access to the 7I96

Take a look at the hm2_eth manual page for information on setting up a static
IP address in the interfaces file.