7i92+7i77 Not connect

More
4 years 3 months ago #246451 by PCW
Replied by PCW on topic 7i92+7i77 Not connect
I would update to the latest mesaflash (3.4.3), reflash the new 7I92s and try again

Please Log in to join the conversation.

More
4 years 3 months ago #246454 by SOLD
Replied by SOLD on topic 7i92+7i77 Not connect

I would update to the latest mesaflash (3.4.3), reflash the new 7I92s and try again
I don't understand for FW7i92s where can it be found.

Please Log in to join the conversation.

More
4 years 3 months ago #246455 by PCW
Replied by PCW on topic 7i92+7i77 Not connect
mesaflash is here:

github.com/LinuxCNC/mesaflash
(build instructions at bottom of page)

7i92 firmware is here:

www.mesanet.com/software/parallel/7i92.zip

Please Log in to join the conversation.

More
4 years 3 months ago #246457 by SOLD
Replied by SOLD on topic 7i92+7i77 Not connect
Update mesaflash to 3.4.3 ok.
reflash the new 7I92 ok.
but not working Please help check the file.

Attachment not found


Attachment not found

 

 

Please Log in to join the conversation.

More
4 years 3 months ago #246461 by PCW
Replied by PCW on topic 7i92+7i77 Not connect
That looks correct, not sure what the issue could be

Do the encoders work?

Please Log in to join the conversation.

More
4 years 3 months ago #247136 by SOLD
Replied by SOLD on topic 7i92+7i77 Not connect
I'm just free for another test.
I don't know how to test the encoder.

Please Log in to join the conversation.

More
4 years 3 months ago #247151 by PCW
Replied by PCW on topic 7i92+7i77 Not connect
Connect an encoder and see if it counts properly on all 6 7I77 encoder inputs

Please Log in to join the conversation.

More
4 years 3 months ago #247157 by SOLD
Replied by SOLD on topic 7i92+7i77 Not connect
How can I see if this is correct when 7i92 is not connected to 7i77? or means setting from the Pncconf wizard

 

Please Log in to join the conversation.

More
4 years 3 months ago #247158 by PCW
Replied by PCW on topic 7i92+7i77 Not connect
I would just comment out all the lines in hal with "7i77"
then you can launch linuxcnc and check the encoders

Please Log in to join the conversation.

More
4 years 3 months ago #247159 by SOLD
Replied by SOLD on topic 7i92+7i77 Not connect
Got it, I'll test it right now.

Please Log in to join the conversation.

Time to create page: 0.059 seconds
Powered by Kunena Forum