7i92+7i77 Not connect

I'm very curious here about why you say it does not connect?
What is different from the other lot that was connecting???

I am moving in the Y axis. but the screen shows the Z axis
Axis X = hm2_7i92.0.encoder.00
Axis Y = hm2_7i92.0.encoder.01
AxisZ = hm2_7i92.0.encoder.02

[video][/ วิดีโอ]
 

When I change the configuration being still connected to the same motor cable
I am moving in the Y axis. But the screen shows the X and Y axis at the same time.
Axis X = hm2_7i92.0.encoder.03
Axis Y = hm2_7i92.0.encoder.02
AxisZ = hm2_7i92.0.encoder.04

***Please note that this internal wiring works, just replace the old 7i92.***


 

Video 2 doesn't show up

Sounds like either:

1. Wrong firmware
2. Bad cable
3. damaged 7I92

I also see on the video that line 74 appear to be wrong:
74 net x-index-enable joint.0.index-enable <==> hm2_7i92.0.encoder.03.  (remaining characters are not visible)
(First video since the other have different settings, which make me think that you should maybe focus on a single configuration as this is very confusing to help with many different configurations)

 

Please note that all configurations are available when I replace my old 7i92 by installing the same firmware.

PCW wrote:

Sounds like either:

1. Wrong firmware
2. Bad cable
3. damaged 7I92

if it is damaged What should I do with all 5 pieces?

So you are saying that the encoders behave differently on the old 7I92 and the new 7I92
when you do _nothing_ but swap 7I92 cards?

SOLD wrote:

PCW wrote:

Sounds like either:

1. Wrong firmware
2. Bad cable
3. damaged 7I92
if it is damaged What should I do with all 5 pieces?
 

I would request an RMA from Mesa, and return the cards for evaluation/repair/replacement