7i76e to Durapulse connection

More
2 years 7 months ago #295773 by gardenweazel
Replied by gardenweazel on topic 7i76e to Durapulse connection
What I have yet to understand is that the pyvcp-panel.xml file uses a value of 3000. Why is that?

I would expect to see these INI values which I assume are RPM?
OUTPUT_MIN_LIMIT = 0.0
OUTPUT_MAX_LIMIT = 24000

 

Please Log in to join the conversation.

More
2 years 7 months ago #295775 by tommylight
Replied by tommylight on topic 7i76e to Durapulse connection
Change it to 24000, save and test.

Please Log in to join the conversation.

More
2 years 7 months ago #295776 by PCW
Replied by PCW on topic 7i76e to Durapulse connection
Those are hardware settings, I would think pyvcp would use
the ini file spindle settings here:

linuxcnc.org/docs/2.9/html/config/ini-co...:ini:sec:spindle-num

3000 RPM is probably the default value if not specified. This does seem like
a pncconf bug to leave out the generic spindle ini settings

Please Log in to join the conversation.

More
2 years 7 months ago #295782 by gardenweazel
Replied by gardenweazel on topic 7i76e to Durapulse connection
Ok, I just added the green FORWARD stuff to my config.. Should I remove the red print?

[SPINDLE_0]
 P = 0.0
 I = 0.0
 D = 0.0
 FF0 = 1.0
 FF1 = 0.0
 FF2 = 0.0
 BIAS = 0.0
 DEADBAND = 0.0
 MAX_OUTPUT = 24000
 OUTPUT_SCALE = 24000
 OUTPUT_MIN_LIMIT = 5000
 OUTPUT_MAX_LIMIT = 24000
 MIN_FORWARD_VELOCITY = 5000
 MAX_FORWARD_VELOCITY = 24000
 INCREMENT = 200
 

Please Log in to join the conversation.

More
2 years 7 months ago #295783 by PCW
Replied by PCW on topic 7i76e to Durapulse connection
No, those are hardware setup parameters and necessary.

Please Log in to join the conversation.

More
2 years 7 months ago #295799 by gardenweazel
Replied by gardenweazel on topic 7i76e to Durapulse connection
Ok, all I did was add those params as described above and everything words as described. 
Here's what I did:

OUTPUT_MIN_LIMIT = 5000   <<-- I changed this from zero to 5000
 OUTPUT_MAX_LIMIT = 24000    <<-- no change to this line
 MIN_FORWARD_VELOCITY = 5000
 MAX_FORWARD_VELOCITY = 24000
 INCREMENT = 200

I added the latter 3 lines in green.

Thanks to those who responded with feedback!

Please Log in to join the conversation.

More
2 years 7 months ago #295801 by PCW
Replied by PCW on topic 7i76e to Durapulse connection
Did that solve the out of range spindle speed error?

Please Log in to join the conversation.

More
2 years 7 months ago #295802 by gardenweazel
Replied by gardenweazel on topic 7i76e to Durapulse connection
Yeah it did believe it or not. 

I'd probably report that as a bug? 

Too weird... 

Please Log in to join the conversation.

Time to create page: 0.058 seconds
Powered by Kunena Forum