Spindle configuration

More
9 years 7 months ago #89820 by Nondepietjes
Replied by Nondepietjes on topic Spindle configuration
The spindle drive is a baumuller BKF12 /120/400.

www.baumueller-services.com/de/downloads...erating-instructions

Attachment not found


Attachment not found

Please Log in to join the conversation.

More
9 years 7 months ago #89822 by andypugh
Replied by andypugh on topic Spindle configuration
OK, that's not a device I know anything about.

Do you see the expected drive signals on the inputs with a multimeter?

Please Log in to join the conversation.

More
9 years 7 months ago #89823 by Nondepietjes
Replied by Nondepietjes on topic Spindle configuration
yes if i send a signal i can measure it.

here is an adjustment of my hal file

Attachment not found

Please Log in to join the conversation.

More
9 years 7 months ago #89824 by andypugh
Replied by andypugh on topic Spindle configuration

Nondepietjes wrote: yes if i send a signal i can measure it.


So, the spindle controller has a valid enable signal and a speed request signal? It seems, then, that HAL is no longer the place to look for the problem?

Please Log in to join the conversation.

More
9 years 7 months ago #89942 by Nondepietjes
Replied by Nondepietjes on topic Spindle configuration
yes, i thing i'm missing a connection but i don't find witch one

Please Log in to join the conversation.

More
9 years 7 months ago #89943 by andypugh
Replied by andypugh on topic Spindle configuration
Does the drive have a fault input? Does it expect to see an encoder or tachometer?

Please Log in to join the conversation.

More
9 years 7 months ago #89945 by Nondepietjes
Replied by Nondepietjes on topic Spindle configuration
Yes, there is an encoder and tacho for feedback. but the encoder is connected correctly. the only thing thas not correct in the document of the drive is the X2 panel.

www.baumueller-services.com/de/downloads...erating-instructions

Please Log in to join the conversation.

More
9 years 7 months ago #89946 by andypugh
Replied by andypugh on topic Spindle configuration
"Sie sind nicht authorisiert diesen Vorgang zu tätigen."

Maybe it needs the X2 panel?

Please Log in to join the conversation.

More
9 years 7 months ago #89947 by Nondepietjes
Replied by Nondepietjes on topic Spindle configuration
Yes i think so. but the X2 panel in the document is not the same as on my machine. X1 panel is correct

Please Log in to join the conversation.

More
9 years 7 months ago #89948 by andypugh
Replied by andypugh on topic Spindle configuration
Any red LEDs?

Please Log in to join the conversation.

Time to create page: 0.077 seconds
Powered by Kunena Forum