can linux cnc can cut a thread using only breakout board without using mesa card

My motherboard have not got a parallel port so I am using a 25 Pin IEEE 1284 Parallel Port D-Sub Connector to USB 2.0 Printer Adapter Cable to connect bob.
is it take any effects on threading?
Realtime matters?

That will not work.
Find the manual for the board, it must have a parallel port header so you will need just a cable with the DB25 connector.
USB can not be used for machine control as it has terrible latency.
Maybe you can use that with Mach3, but i do not use it so i can not hell with that, and i am not aware that mach can do threading .....

No eBay APP ID and/or Cert ID defined in Kunena configuration

Is this recommended?

Hard to tell, some of them do work some do not.
Most that use MOSCHIP IC do work.
What motherboard are you using ?

No eBay APP ID and/or Cert ID defined in Kunena configuration1)LENOVO ThinkCentre A52 CAYMAN-RH 945 motherboard not worked since a year
2)biostar g31-m7 te

parallel port card on ebay

Already replied to the other thread, please do not make multiple threads with the same questions.
The Biostar has a header for parallel port so you need just the cable with the connector, it is the pink header on the mainboard. You do not need a parallel port card for that motherboard.
Regards,
Tom

No eBay APP ID and/or Cert ID defined in Kunena configuration

Is this suitable for my board?

Replied by tommylight on topic can linux cnc can cut a thread using only breakout board without using mesa card
Already replied to the other thread, please do not make multiple threads with the same questions.

Sorry for inconvenience.
I will not post multiple threads again!

No worries, it just makes it difficult for someone else to find that information later.
Yes that is the connector you need fro the Biostar board.
Regards,

Should I install driver to parallel port to make it work?