Plasmac parport connections

I'm gona give friquency input to in
What you mean by hal name of parport pin i entered parport. 0.pin-n-out
Is it right???

I did as u said its giving an errro
Can not find - sec task - var task - num 1
And thanks to admin i cant post any pics

It would be parport.0.pin−<n>−in or parport.0.pin−<n>−in-not.

I don't know what that error means.

If you are using a frequency then you probably need to feed that into an encoder then use the velocity output of the encoder for the arc voltage.

Are you using a THCAD?

I didn't connected it to my parport physically
I'm using diy circuit
But leave that as it's other topic
FOR NOW I JUST WANT MY AXES TO JOG INSIDE PLASMAC... EVEN A SINGLE AXES JOG ALSO ENOUGH

Can you post your ini file and ALL your hal files and I will have a look tomorrow.

@Bushan
Stop making ofending comments.
What is your native language ?

From the begining:
Do you have a THC like THCAD or Proma THC150 or similar?
From your posts you mentioned several times that you do not have a THC, so why do you insist on using such a config ?
Make a simple config and use the machine, you can use a simple DC motor instead of the Z axis motor with two switches to lower or raise the torch while cutting.
For PlasmaC you need to have a working normal config then use the PlasmaC manual to see what you need to edit and what to copy where.

Bushan,

The docs clearly states one of the first things to do is get a working config. Which has nothing to do with Plasmac.

Get your machine working and jogging three axis before doing anything with a Plasmac config.

sorry for my arrogent behaviour earlier

is this right
or do i need to make any changes in ini and hal files of my base config
thanks
oppps sorry theres an out pin for torch on

I would be of great help if you post the base_config.ini file & it's companion HAL file. Followed by the files that are generated by configurator.py

i edited ini file and tried again it still terminated with error