Poti for overrides

yes it is, and no I didnt. I my google-fu has failed me and while I found lots of information on hysterectomies, Not much about the hyst component haha.

the hyst comp is not included in linuxcnc

download archive here: forum.linuxcnc.org/24-hal-components/360...gger?start=10#151335
unpack archive
install with halcompile

Thanks Roland,
That was what I was going to ask next.,as the value bobbed around , can you post the lines you added after compiling the hyst comp.Im looking to modify the feed pot..

You can see my config in the attached hal files.
The feed pot and the rapid pot makes 5% Steps

Thanks again Roland,
Works fine. Giving me the urge to add Rapid OVR also. I however set it to 1% increments, more used to it.

I could really use this hyst.comp to settle down jumpy analog overrides.

Unfortunately the comp file archive linked here is no longer available and I can't figure out if something similar has been added to linuxcnc in the meantime.

Is there now a better way to do this kind of thing natively in Linuxcnc 2.8.1 or does it still require a custom component?

Maybe someone has a copy of that original hyst.comp file that I could use?

Cheers
Linus

 

Thank you!

Hi, I have mesa 7i77 and I get this error, what am I doing wrong?
 

Most likely the 7I77 is not set into a mode that supports analog inputs
Modes 1,2,3 support analog inputs

You change this with the "sserial_port_0=Something" command line argument
in the hal or ini file.

With most 7I77 firmware, sserial_port_0=200xxx should work