Hello,
after problems with my Linux i decided to save my configuration and reinstall Linux.
I used the 2.8.2 Linux installer, but then after i found out about the not working axis motors i upgraded to 2.9, which did not fix the problem.
I am using the exactly same config as before the linux problem.
My physical buttons and potentiometers are working fine, spindles starts and stops, etc. but when i want home, my motors just dont move, but they are powered.
I am using GMOCCAPY.
I uploaded all my files as .RAR, i hope thats fine and i hope someone can help me out with that.
I am getting no error messages when starting LinuxCNC, so i do not understand why the motors are not moving when using the previously working configuration without any changes.
