MESA THCAD-2 - couple quick questions

Thanks again, to all.

My build progress can be followed here: forum.v1engineering.com/t/lowrider-3-pla...arksburg-wv/33849/77

Great job, thank you.
Seen this before, nice to see you keep it up to date always.

Hello again! Thanks for being so awesome, guys.

My next burning question is about my THCAD2 being missing in the THCAD dropdown on the MESA THCAD page of the PNCconf wizard.

There are three choices: 5, 10, and 300.

But on the MESA website there are four choices to buy from: 2, 5, 10, and 300.

I bought the THCAD2.

What should I do on that setup page? Thanks in advance for any nudge in the right direction!

For anyone wondering about the last question, it was answered in another thread. Thank you!

This thread/topic
forum.linuxcnc.org/27-driver-boards/4780...-led?start=20#260795

I have added the THCAD-2 to both PnCconf and stepConf as well as lowering the minimum zero volts frequency.
It should be available from the Buildbot.

That's amazing. Thank you!!

Thanks for the report, I wan't aware that the THCAD-2 existed.