Index to Linuxcnc & the Raspberry Pi (4 & 5) Official Images Only!!!

Intro:
I'm trying to index some of the issues, solutions and info contained in the thread mention in the title. As I would like to keep this "clean", it would be great if any new issues,queries additional info be posted here: forum.linuxcnc.org/9-installing-linuxcnc...official-images-only
(yes I know Raspberry is spelt wrong)
Cheers
Rob

General Stuff
About the Images: forum.linuxcnc.org/9-installing-linuxcnc...-only?start=0#320270

Networking Topics
Installation of Network Manager: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#320949
Network Setup by behai: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#320967
Additional Comments by Rodw: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#320972
Ethercat Status: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#321684
Simple Mesa Setup without Network Manager by PCW: forum.linuxcnc.org/9-installing-linuxcnc...only?start=30#323321
wifi setup without Network Manager: forum.linuxcnc.org/9-installing-linuxcnc...only?start=40#323701

Locales:
Locales by behai: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#320959

GPIO
Note that the below may help with those stuggling with Byte2Bot boards.
Regarding GPIO drivers:  forum.linuxcnc.org/9-installing-linuxcnc...-only?start=0#320852
Basic Mill Config: forum.linuxcnc.org/9-installing-linuxcnc...only?start=10#321296
Thread related to issues when SPI is enabled and the user wishes to use SPI GPIOS: forum.linuxcnc.org/24-hal-components/564...not-be-solved#330574

Video/b]
Skewed Video Issue & Solution by 109jb:  forum.linuxcnc.org/9-installing-linuxcnc...only?start=30#322167

Swap - zswap
Initial issue & Solution:  forum.linuxcnc.org/9-installing-linuxcnc...only?start=30#322251

UI Isuues:
GMOCCAPY locking up when idle by U2fletch: forum.linuxcnc.org/9-installing-linuxcnc...only?start=40#323825
Solution: forum.linuxcnc.org/9-installing-linuxcnc...only?start=50#324087
Notes: This was related to zswap.

If we fix the berry bit will the links still be good or do they need modifying ?
Pinning it would be a good idea, was hoping you would ask
Locking just to keep it clean, I like it

Thanks
Tommy

Extra Wired Network config
forum.linuxcnc.org/9-installing-linuxcnc...only?start=80#327930

NFS Mounts & Wifi On Boot
forum.linuxcnc.org/18-computer/57167-rpi...twork-file-share-nfs

Fixed tittles for both, links still work, pinning it and locking it now so if you can not post or edit do let me know on the other topic.
Thank you.