Joining two motors

tommylight wrote: In the ini file there are missing

In the hal file, delete the ....maxerror......=0.005 lines.

On an inch machine, that setting is fine.

cmorley wrote:

tommylight wrote: In the ini file there are missing

In the hal file, delete the ....maxerror......=0.005 lines.

On an inch machine, that setting is fine.

Nice to know, thank you Chris.

I’m using 2.9. Ok thank you. I’m not good at editing the files but I’ll try and let you know when I get home. Thank you

ok here try this -replace your old file with this.

Sorry, im kinda having trouble replacing this. I’m not sure if I’m really doing it right. Again I’m not familiar with this so I’m just trying to take what you posted and replace the one in the folder. Do I have to decompress it or something?

Aldenflorio wrote: Sorry, im kinda having trouble replacing this. I’m not sure if I’m really doing it right. Again I’m not familiar with this so I’m just trying to take what you posted and replace the one in the folder. Do I have to decompress it or something?

Chris is wanting you to replace your ini file with these contents. First copy your <filename>.ini to another name so you can revert back if you have to.

Open Chris's file select all text copy then open your ini file, select all then paste. save and then do your stuff.

That’s what I thought. But when I open my ini file it opens as like some terminal and I can’t select all the text or paste

Here is your compressed files - with the changes
Hopefully that is easier..

Could you post your plasma_cutter.pncconf file - I'd like to figure out why it configured wrong.

This is it. but its after i replaced the file you sent. now im getting an error message.
imgur.com/gallery/C5s1iDR