pncconfig error

More
5 years 11 months ago #188465 by PCW
Replied by PCW on topic pncconfig error
g540x2

Please Log in to join the conversation.

More
5 years 11 months ago #188466 by kevin19
Replied by kevin19 on topic pncconfig error
I changed the firmware but I do still get an error...:(

Attachment not found


Attachment not found

Please Log in to join the conversation.

More
5 years 11 months ago #188468 by PCW
Replied by PCW on topic pncconfig error
Did you flash the FPGA card with the 5i25_g540x2.bit firmware?

sudo mesaflash --device 5i25 --write 5i25_g540x2.bit
sudo mesaflash --device 5i25 --reload

Please Log in to join the conversation.

More
5 years 11 months ago #188482 by kevin19
Replied by kevin19 on topic pncconfig error
thank you for your help:)

Please Log in to join the conversation.

More
5 years 11 months ago #188508 by kevin19
Replied by kevin19 on topic pncconfig error
I do have a question concerning the step, dir,enable, reset, fullstep, and fault output functions of my 4 gecko drivers. Mechanically I have connected them to the db25F connector(P3) and HDR26 connector(P2), but how and where should I configure them in pncconf?

Attachment not found


Attachment not found

Please Log in to join the conversation.

More
5 years 11 months ago #188518 by PCW
Replied by PCW on topic pncconfig error
Did you select g540x2 and the press "Accept components Changes"

Do you have a 7I75 in between?

Please Log in to join the conversation.

More
5 years 11 months ago #188520 by kevin19
Replied by kevin19 on topic pncconfig error
Yes, I did press "accept components changes". I use the 7i75 breakout board for step, dir, enable functions and limit switches and hdr26 breakout board for the other functions as you can see in my wiring diagram.

Attachment not found

Please Log in to join the conversation.

More
5 years 11 months ago #188521 by PCW
Replied by PCW on topic pncconfig error
Does the I/O connector 3 tab show the stepgen pins?

Please Log in to join the conversation.

More
5 years 11 months ago #188522 by kevin19
Replied by kevin19 on topic pncconfig error
Yes it is, so it includes step and dir functions both right?

Attachment not found

Please Log in to join the conversation.

More
5 years 11 months ago #188527 by PCW
Replied by PCW on topic pncconfig error
Yes the step generator setup is done by step generator number.
(which can be a little confusing as the I/O is setup by GPIO number)

Please Log in to join the conversation.

Time to create page: 0.061 seconds
Powered by Kunena Forum