Cannot get stepper motors to move

More
4 years 8 months ago #234070 by PCW
Replied by PCW on topic Cannot get stepper motors to move
Have you enabled EStop in the configuration? this might
cause this behaviour if the external signals are not correct

Please Log in to join the conversation.

More
4 years 8 months ago #234071 by Jalapeno56
Replied by Jalapeno56 on topic Cannot get stepper motors to move
I just double checked, e-stop is not enabled

Please Log in to join the conversation.

More
4 years 8 months ago #234075 by PCW
Replied by PCW on topic Cannot get stepper motors to move
Can you post your hal and ini files?

Please Log in to join the conversation.

More
4 years 8 months ago #234077 by Jalapeno56
Replied by Jalapeno56 on topic Cannot get stepper motors to move
Yes, they are at the beginning of this thread, I have not changed them yet.

Please Log in to join the conversation.

More
4 years 8 months ago #234111 by Jalapeno56
Replied by Jalapeno56 on topic Cannot get stepper motors to move
Sorry, I had threads confused...
Here are my hal and ini files

Please Log in to join the conversation.

More
4 years 8 months ago #234115 by Jalapeno56
Replied by Jalapeno56 on topic Cannot get stepper motors to move
Motors will jog now. Deleted all wired connections and started over. Only thing I can think of is that maybe an old setting was interfering from when I used the wired connection to install Debian 11.
Thank you everyone for the help!!

Please Log in to join the conversation.

Time to create page: 0.049 seconds
Powered by Kunena Forum