PNCconf 7i92H and 7i76

What do you have?

excuse me, what are you referring to and do you mean "what i have"?

Title says 7i92H and 7i76, but in one of your last posts you mention 7i96S, so what do you have?

I have installed a 7i92H in the machine.
I have the 7i96S as a replacement and it doesn't play a role here.
I apologize for the misunderstanding

what other information did you want to write to me?

Did you try moving the machine?

i am confused, i would like to ask my question again about my understanding.
which axes of the machine should I move?
for me the question arises, is the generated PncConf file a pure simulation, or does it already affect the real machine?
If the latter, I would like to know how the file can intervene? Does the FPGA have the necessary information?

ok, I start the PncConf file, switch the emergency stop "off" - i.e. the machine is switched on and try to reference and get the following error messages

 

Use PncConf to edit the existing config, on the input pins page invert all 4 sensor pins.
Edit.
First make sure the sensors are not triggered.

executed, reference runs of all axles started - but runs rather slowly