Updating pncconf for 7i95t

Unfortunately, I don't have the 7i95T board assembled yet - I'm waiting for some parts - only the servo is provisionally connected. If I create a simple x-configuration in Config Tool 2, I can move the servo.

A friendly warning:
Never ever plug or unplug the 5V connector to Mesa board while the power supply is on!!!

Yes, it is still disconnected because I am waiting for the installation of the fast overvoltage electronic efuse TPS2596

alexandrap wrote:

Yes, it is still disconnected because I am waiting for the installation of the fast overvoltage electronic efuse TPS2596

To the 5V Mesa power?
I do not think any fuse is faster than silicium/silicone inside the chips.
Put a switch on the primary side of the power supply.

texas instruments TPS2596 - 2.7 to 19 V, 0.125 to 2-A, 89-mΩ eFuse With Accurate Current Monitor and Fast Overvoltage Protection


Adjustable overvoltage lockout (OVLO) with a
response time of 1.3-μs (typical

after editing the PNCCONF according to kworm - update 
forum.linuxcnc.org/39-pncconf/56464-mesa...thcad-pncconf-screen

is possible to configure the step-dir spindle in 7i95T