7i76E Spindle configuration

I can't configure the spindle, the configuration screen doesn't appear.
 also can't choose the PWM signal or CW - CCW.
I am on 2.9.5 and I don't understand what I'm doing wrong.

There is something that changed, in version 2.7.15 of LinuxCNC it could be done without problems, now it is impossible for me, I don't understand what is happening, I can't find information to guide me. Thank you.!!!

There is no PWM involved (at least at the configuration level)

pncconf setup looks like:


 


and:


 
 

yes!

I can't see that page, it goes up to P1-P2.

I see only TB2/TB3 P1 P2

it doesn't allow me to add a PWM. I set it to 1 and it goes back to 0

I suspect this may be a localization bug in pncconf

If you run pncconf from the command line, does it print any error messages?

I can run it from the console without any problem.

Can the network configuration affect?

 

Can the network configuration affect?

No, the FPGA card need not even be present for pncconf to run

I would try setting the locale to en-US

Could someone set up a 4 axis + 1 spindle of 24000 rpm with pncconf?
I assembled 2 computers with 2 7i76e motherboard boards and both are experiencing the same issue.
I can program manually with cw cww enable and it works perfectly, but when I want to incorporate a pwm component, it gives me an error.
If I can obtain the .hal and .ini files, I can modify them and proceed with a machine that I need to get working.
thank you!!!!!!

Here's a pncconf created basic 4 axis configuration with spindle:


 

 

Thank you very much!!!!!