Help with probe/tool setter in qtdragon

I have a Mesa 7i96 card, my ground is set to pin 10 I think, pin 8 is the touch probe, pin 9 is the tool height sensor. I don't think I can set each differently, so I have to have either port 8 or 9 trigger the probe. 

When I tried to put an or in my HAL, it gave me a pin not defined error.

What is the best way to implement this? I know the probe and touch plate work because the leds on the Mesa card show when they are triggered.

Thanks

Maybe you can find something useful here:
forum.linuxcnc.org/10-advanced-configura...robe-and-touch-plate
forum.linuxcnc.org/10-advanced-configura...-tool-setter-z-touch