Envoie d'un email lorsque l'usinage est terminé

Bonjour, j'aimerais envoyer un email lorsque l'usinage est terminé.
avez-vous une méthode pour cela.

Merci

Hello, I would like to send an email when the machining is finished.
do you have a method for that.

Thank you

I think that this should be fairly easy, though I have not seen it done.

Some discussion (with no answer) forum.linuxcnc.org/38-general-linuxcnc-q...ool-change-etc#84147

If you can add an M-code to the end of the G-code file then is seems fairly easy in theory.

If it needs to work for any G-code file without modification then this seems like a job for either a HAL component that monitors program.is-running or possibly a remap.