Run/Step Hold/Resume Buttons

andypugh wrote:

Bhushan wrote: listen u ###### i dont know how to connect hal pins to signals or components
if u can help just help or just dont do anything

I am suspecting that LinuxCNC might not be the right solution for you.

Have you read the HAL documentation ?

He did get it to work as he mentioned it in another thread, but he is to shy to say he's sorry !

tommylight wrote: He did get it to work as he mentioned it in another thread,

Ah, right. As you might have guessed I am running a forum backlog of about a week.

Lol I apologize from bottom of my heart for being sooo irritating.....
I AM SORRY

i copied and pasted it inside my custompostgui.hal
aslo changed input to parport.0.pin-15-in
this error occures

You are referring to a mesa pin when you have a parallel port so no wonder it is not found.

This configuration works perfectly
But i want my pause and resume button's externally also not on toggle but two saprate buttons

andypugh wrote:

tommylight wrote: He did get it to work as he mentioned it in another thread,

Ah, right. As you might have guessed I am running a forum backlog of about a week.

Well same her but some 3 weeks roughly in backlogs, still chasing my tail !

Bhushan wrote: This configuration works perfectly
But i want my pause and resume button's externally also not on toggle but two saprate buttons

You should start a new thread in the Hal section, this section is for working examples.

JT

just use a OR chain to get your 10 buttons on one action
right it down first befor starting programming into
and ofcause do all the stuff at a postgui file then you can have realy good success on a 4 corner panel with all actions around the "house"

pl7i92 wrote: just use a OR chain to get your 10 buttons on one action

The "logic" HAL component can be used to make a single 10-input OR if required.

linuxcnc.org/docs/2.8/html/man/man9/logic.9.html