Run/Step Hold/Resume Buttons

Use one or2, and put in the output the pin halui. home.all

Ok, the first thing was difficult for me but it now seems to be functional, thank you very much COFHAL!!
The only thing I have observed is that with the physical button it only works when starting LinuxCNC, then it gives me a message "you must be in joint mode for home" while that does not happen with the MPG button, it makes home again and again every time I press it. pulse (totally lost with this).

On the other hand, I have continued with the physical power button, I have done exactly the same, but it gives me the error that I attached in the report, I am sure I am missing something, I am convinced that it cannot be so simple anymore.

Habla español?

custom_postgui.hal:117: Signal 'botonencendidoseñal' can not add OUT pin 'halui.machine.is-on', it already has OUT pin 'botonencendido.out'

COFHAL wrote:

Habla español?
 

Si!! soy de Bilbao   Tu?

custom_postgui.hal:117: Signal 'botonencendidoseñal' can not add OUT pin 'halui.machine.is-on', it already has OUT pin 'botonencendido.out'

I know that's the error, what I don't quite understand is why, having done the same thing as the other button and I don't know how to solve it. I had thought about using the unlink command but I am sure that it is not the most appropriate and that it could be done in a simpler and cleaner way.

Greetings.

De Colombia, mañana verifico bien y le confirmo donde esta el error, seria bueno que publicara toda su configuracion.

The .ini and .hal file you mean?

If you want I can share the email or another way too and so we don't saturate this thread.

Cofffffhal&&&

Очень хочу подключить кнопку начало исполнения программы ,можете помочь?

The following is block diagram based on BJT Run/Step Hold/Resume Buttons hal netlist file as shown at the beginning of this discussion.
  Now, let’s start little tutorial that show how you can generate hal file from a block diagram:Let’s take the first line of the block diagram and convert it into hal netlisting:
  I let you do the rest as an exercise. Once you get hang of converting block diagrams to hal netlist you will find that it makes creating hal solutions much easier.Now if you would like to automatically generate hal file from block diagram. The one I use is eagle2hal see LinuxCNC wiki or even better use Ed Nisley kicad to hal. softsolder.com/2021/03/25/kicad-to-hal-basic-schematic-symbols/