7i73 8x8 matrixkey how to map number

COFHAL wrote:

Yes, To simulate keyboard keys use the scancode component linuxcnc.org/docs/html/man/man1/sendkeys.1.html .

Thank you for fast reply MR. COFHAL
I read in link but still confused about the variable format.
I try 

Code:

sudo groupadd -f uinput sudo gpasswd -a (myuser) uinput create file on your location 99-input.rules sudo echo KERNEL=="uinput", GROUP="uinput", MODE:="0660" | sudo tee /etc/udev/rules.d/88-input.rules and restart 

Try , ls -l /dev/uinput
result : (its have respond result but not sure I forgot take photo and now back home)

Code:

I try add this in main hal file[code]loadusr -W sendkeys config=s64t10 net  scancodes hm2_7i96s.0.7i73.0.3.keycode => sendkeys.0.keycode setp sendkeys.0.scan-event-00 34 # Key G setp sendkeys.0.scan-event-01 2 # Key 1 setp sendkeys.0.scan-event-02 3 # Key 2 setp sendkeys.0.scan-event-03 4 # Key 3 setp sendkeys.0.scan-event-04 50 # Key M setp sendkeys.0.scan-event-05 05 # Key 4 setp sendkeys.0.scan-event-06 06 # Key 5 setp sendkeys.0.scan-event-07 07 # Key 6 setp sendkeys.0.scan-event-08 31 # Key S setp sendkeys.0.scan-event-09 8 # Key 7 setp sendkeys.0.scan-event-10 9 # Key 8 setp sendkeys.0.scan-event-11 10 # Key 9 setp sendkeys.0.scan-event-12 20 # Key T setp sendkeys.0.scan-event-13 11 # Key 0 setp sendkeys.0.scan-event-14 52 # Key Dot setp sendkeys.0.scan-event-15 14 # Backspace setp sendkeys.0.pin-event-00 29 # Left Ctrl setp sendkeys.0.pin-event-01 57 # Space setp sendkeys.0.init 1

[/code]
I try open linuxcnc , can boot up.
I powerOn and change to MDI mode and click in space MDI.
I try use Keyboard can type in MDI , I try press all in matrixkey (64keys) , not any respond in MDI 

how can I check correct or wrong about setup ?
I have question   , If I want key.r5c5  from matrixkey   to map    Key G  how to  setp ?

Code:

[code][b] [/b]

[/code]