http://buildbot.linuxcnc.org stretch Release' does no longer have a Release file

More
6 years 3 months ago #175675 by Pro_El
Replied by Pro_El on topic http://buildbot.linuxcnc.org stretch Release' does no longer have a Release file
does not have a Release file too. cannot update to 2.8

Please Log in to join the conversation.

More
6 years 3 months ago #175690 by Cerna
Replied by Cerna on topic http://buildbot.linuxcnc.org stretch Release' does no longer have a Release file
The Buildbot appears to be again online. However it hasn't yet started building commits which were pushed when it was online (i.e. be66efa8d7b051a232802057cdc80bfc82f2c2de) and I don't think it is going to. So one will have to wait if it will catch a new commit and if it then pushes it to the registry.

Please Log in to join the conversation.

More
6 years 3 months ago #175691 by tommylight
Replied by tommylight on topic http://buildbot.linuxcnc.org stretch Release' does no longer have a Release file
That is not the link to packages that we need for installation.
That is still not working.

Please Log in to join the conversation.

More
6 years 3 months ago #175695 by Cerna
Replied by Cerna on topic http://buildbot.linuxcnc.org stretch Release' does no longer have a Release file

tommylight wrote: That is not the link to packages that we need for installation.
That is still not working.


I know, however part of the process is to create the packages (after RIP and test) and upload them to the registry. And the registry files (which packages are available and such) has to be updated also - I presume that it is done as part of the build process, because it has to be.

That could actually repair the package instinstallation

Please Log in to join the conversation.

More
6 years 3 months ago #175731 by ikkuh
Replied by ikkuh on topic http://buildbot.linuxcnc.org stretch Release' does no longer have a Release file
I got the following versions today:
Code:
Get:1 http://buildbot.linuxcnc.org stretch/master-rtpreempt i386 linuxcnc-doc-en all 1:2.9.0~pre0.2413.g10adc16cb [16.7 MB] Get:2 http://buildbot.linuxcnc.org stretch/master-rtpreempt i386 linuxcnc-uspace i386 1:2.9.0~pre0.2413.g10adc16cb [11.3 MB]

Please Log in to join the conversation.

More
6 years 3 months ago #175751 by tommylight
Replied by tommylight on topic http://buildbot.linuxcnc.org stretch Release' does no longer have a Release file
It is back and working, just did an update/upgrade on one of my systems.
Thanks to whoever fixed that.

Please Log in to join the conversation.

Time to create page: 0.051 seconds
Powered by Kunena Forum