Debian 11/ Bullseye / MX Linux 21 - how to run a buildbot AND RIP install?

robertspark wrote:

I installed Debian 11 in a time window I had.... it was missing a driver for my WiFi (fairly newish card.... always worked / loaded fine in Debian 10)

MX-21 was taking way too long ( cement through a straw!)

sort all the rest later

What is your wifi card (make and model) Is it USB?

wifi all sorted now (its an intel one, needed non-free contrib repository)

try again....  This may be of help to you Rod, it did work for me just fine:sudo geany /etc/lightdm/lightdm.conf
scroll down to about line126 and uncomment (remove #) both of the following lines and add YOUR login user nameautologin-user=rob
autologin-user-timeout=0
 

well... progress... make RIP at present.

Linux RobsCNC 5.10.0-8-rt-amd64 #1 SMP PREEMPT_RT Debian 5.10.46-4 (2021-08-03) x86_64 GNU/Linux

dependencies were "interesting".... but sorted now

for a RIP build on Debian 11 / MX-Linux 21, what did you do for missing dependancy:
libgl1-mesa-swx11-dev {never mind.... seems to be something of a carry over from Jessie)

RIP Errors, on MX-Linux 21 (Debian 11)

Opening the QTPlasmaC Sim following build / RIP and Gmoccapy 4 axis Sim



 

python-opengl missing.... for gmoccapy as a dependency

From the errors, looks like you missed a few dependencies. Did you open the spoiler in this post hat had them all in it?
forum.linuxcnc.org/38-general-linuxcnc-q...stall?start=0#217208

Just paste it in again, remove any it can't find so it runs. It will ignore anything not required.

robertspark wrote:

python-opengl missing.... for gmoccapy as a dependency

I think that should be pyton3-opengl but it might resolve to the version

sudo apt-get install python3-PyQt5.Qsci python-dbus.mainloop.pyqt5

keep them coming I'm updating my list

and python3-pyqt5.qtwebengine