- Posts: 8
- Thank you received: 0
Axis Gui will no longer home X and Z (lathe)
4 years 6 months ago #240994
by dreiii
Replied by dreiii on topic Axis Gui will no longer home X and Z (lathe)
I tried to update from within Wheezy using software update and got an error message similar to "repository no longer exists, out of date xxxxx days xxxxx hours xxxx minutes or something similar to that.
Is there some other way that I am (sure) that I do not how to use. I am very limited in knowledge of Linux.
Is there some other way that I am (sure) that I do not how to use. I am very limited in knowledge of Linux.
Please Log in to join the conversation.
4 years 6 months ago #240998
by andypugh
Replied by andypugh on topic Axis Gui will no longer home X and Z (lathe)
The LinuxCNC update is independent of the Wheezy repositories.
linuxcnc.org/docs/stable/html/getting-st...e_to_the_new_version
linuxcnc.org/docs/stable/html/getting-st...e_to_the_new_version
Please Log in to join the conversation.
Time to create page: 0.500 seconds
