So, it now goes in reverse at 1rpm.
Does it only do 1 rpm in both directions?
I hope it works as it must. Not tried.
If there are a max and a min speed in 2000 rpm I hope it will do it, like it was configured.
I'm assembling simple CNC Machines and the PNCConf was enough to configure them (I'm using the LCNC manual rarely) and a few manual changes for external buttons and alarms from drivers and simple turret on a lathe (if there is a ready example jus to connect the pins and edit a few files).
Still have no ide, how to make a lathe spindle use like a rotary axis in step/dir mode (+ orientation). My firs language is not english, so it's difficult to understand the manual and the technical information, plus I'm a civil engineer. So I'm not understand what pin i need to connect to what. And what will it do.
