Locations of LinuxCNC

The locations of LinuxCNC .deb files (deb is an abbreviation for Debian package) can be somewhat hard to find so here are all that I know of.

linuxcnc.org/dists/
buildbot.linuxcnc.org/dista/
buildbot2.highlab.com/

Debian 12 and up can use apt to install LinuxCNC

JT

buildbot.linuxcnc.org/dists/
This is not the same as
linuxcnc.org/dists/
On the latter , there are entries for BookWorm and BullsEye, but on the Buster folder there are no debs for anything above 2.8.
On the first link there are Buster debs for all versions, and there are no BookWorm and BullsEye folders.
-
To keep this clean, delete this post.
Thank you.

On linuxcnc.org/dists/ I've manually uploaded an armf deb for Rpi 4. Gotta work on arm64 deb next both are for Debian 11.

JT

We could also put LinuxCNC debs for Linux Mint on linuxcnc.org/dists/ if someone wants to build them and make them available to me.

JT

Linux Mint 19.n uses debs from our Buster repo.
Linux Mint 21.n used debs from the official Debian BookWorm/BullsEye repo. Or is it SID?
Skip Mint20.n, as far as you possibly can !
Our debs do not work with Mint 21.n, at least till over a month ago.

JT wrote:

On linuxcnc.org/dists/ I've manually uploaded an armf deb for Rpi 4. Gotta work on arm64 deb next both are for Debian 11.

JT

If you want the versions for arm64 I can provide them (i. e. 2.8.4 buster, 2.9.0pre bullseye and 2.10.0pre bookworm) tested on Pi3B+, Pi4B and Pi400

Where can I download them from?

JT

At the moment these links are available:

(tested on Debian Bookworm)

linuxcnc-uspace_2.10.0~pre0_arm64.deb

linuxcnc-uspace-dev_2.10.0~pre0_arm64.deb 

(tested on Debian Bullseye)

linuxcnc-uspace_2.9.0~pre0_arm64.deb

linuxcnc-uspace-dev_2.9.0~pre0_arm64.deb

Tomorrow I will upload those for 2.8.4 (tested on buster)

Both dev debs are only 246kB in size and I expected at least 1MB or more in size so I think something is wrong with them.

Jt

JT wrote:

Both dev debs are only 246kB in size and I expected at least 1MB or more in size so I think something is wrong with them.

Jt

Strange, now I check again.

Perhaps it is due to the fact that the compilation does not include the documentation?

The commands I run are:

debian/configure no-docs
dpkg-checkbuilddeps
debuild -uc -us

However, the debs with the various languages are the same for both the armhf and arm64 version