LINUXCNC on Raspberry PI 5 2GB

I have a RPI 5 that will not install from the LinuxCNC 2.9.2 Raspberry Pi 5 OS based on Debian Bookworm i mage.
The RPI 5 is only the 2GB version. Would this be the problem?
THis RPI 5 works ok from the nomal Raspberry PI imager program

 

Try using Balena Etcher  to burn your image. There is an issue with the pi imager

Try also the image from this link:

forum.linuxcnc.org/9-installing-linuxcnc...pi-5?start=40#303752

I think I tried Balena Etcher
But yor link above work. You are a Star

I did read some were that the 2 GB RPI 5 has a new die revision so I thought this may have been an issue somehow.

Many thanks. Martin