Linux_Mint_22.1_LinuxCNC_2.10.iso

Will try to upload the new build with 6.13 RT kernel later tonight, WiFi works on both of my laptops with it, whereas it did not work with 6.10.
Also, display refresh rate was 60Hz max with 6.10, with 6.13 it's 120Hz as it should.

Link on the original post updated with the new version with 6.13 RT kernel.

I'm having a problem, it wants me to log in to the drive.

 

 

Should be fixed now.
Sorry.

Is there a way to get the Header Files for the RT-Kernel installed? I've tried to install the linuxcnc-ethercat Master, because i´d like to use it with Mint. I  prefer Mint a little more over Debian.

 

sudo apt install linux-headers-$(uname -r)

tommylight wrote:

sudo apt install linux-headers-$(uname -r)
 

I tried to install the headers with your above mentioned command without any luck.
is there another way to find and install the header files?

linuxcnc@linuxcnc-mint:~$ sudo apt install -y linux-headers-$(uname -r)
[sudo] Passwort für linuxcnc:          
Paketlisten werden gelesen… Fertig
Abhängigkeitsbaum wird aufgebaut… Fertig
Statusinformationen werden eingelesen… Fertig
E: Paket linux-headers-6.13-rt-amd64 kann nicht gefunden werden.
E: Mittels des Musters »linux-headers-6.13-rt-amd64« konnte kein Paket gefunden werden.

 

ftp.de.debian.org/debian/pool/main/l/lin....13.8-1~exp1_all.deb

ftp.de.debian.org/debian/pool/main/l/lin....11-1~exp1_amd64.deb

This is all i can find, it is an experimental kernel, so no support for it and it keeps changing.

Tommy
Have you tried the r8168-dkms driver? I installed it and lost my Ethernet connection to the Mesa board. It could be me or the 6.13 kernel.
It works with the original driver, but I get the Read error problem.

scotth wrote:

Have you tried the r8168-dkms driver?

No, never needed it.
Do a latency test with
latency-histogram --nobase --sbinsize 1000 -- show
leave it for at least half hour while running some glxgears and youtube videos, especially changing the video to full screen several times.
Also what ping times do you get with 6.13 ?