LinuxCNC post-processor error. Please assist

I purchased a DIY CNC plasma table. I've got everything assembled and running; I've even managed to get the machine to run the g code that the previous owner had programmed into it. I wanted to sketch and use fusion's CAM capabilities because I am familiar with it. However, I receive a message stating that plasma is not supported when I attempt to publish process using LinuxCNC as the post. Why am I misusing this? LinuxCNC reportedly supports plasma.

youtube thumbnail download
 

Yes, linuxcnc support plasma as well as fusion 360. AFAIK, the problem is that there's no 'official' post available for this. See here: cam.autodesk.com/hsmposts ? You will find many posts for 'waterjet/laser/plasma' but none of them are for linuxcnc.

Then, a quick search at Autodesk HSM community revealed this posts: forums.autodesk.com/t5/hsm-post-processo...ocessor/td-p/8112836 See the linuxcnc plasma post near the end of the thread. Maybe this would work for you. If not I would suggest to ask there.

 

Your post is a bit vague.  Are you running plasmac or qtplasmac?  Or is some other software driving the table?

If you are running plasmac or qtplasmac, you could try this post:

forum.linuxcnc.org/plasmac/38438-plasmac-post-processors#159042