Daughterboard inputs not recognized in HALMETER

andypugh
Offline
Administrator

8 years 11 months ago #101201 by andypugh

Replied by andypugh on topic Daughterboard inputs not recognized in HALMETER

It should just need something like:

Code:

net home-X-raw hm2_5i25.0.7i76.0.gpio-00-in debounce.0.0.in
net home-X-filt debounce.0.0.out axis.0.pos-lim-sw-in axis.0.neg-lim-sw-in axis.0.home-sw-in

For each axis.

(motion pins are listed here: linuxcnc.org/docs/2.7/html/man/man9/motion.9.html )

Please Log in to join the conversation.

Dubmfg
Topic Author
Offline
Senior Member

8 years 11 months ago #101203 by Dubmfg

Replied by Dubmfg on topic Daughterboard inputs not recognized in HALMETER

Woohoo! Plugged in the logic from my Linuxcnc .HAL and edited a bit of the postgui and now Its all working! Will post what worked for future people (likely me) to use as a reference for this combination.

Please Log in to join the conversation.

Dubmfg
Topic Author
Offline
Senior Member

8 years 11 months ago #101209 by Dubmfg

Replied by Dubmfg on topic Daughterboard inputs not recognized in HALMETER

Attached is my funtioning HAL, POSTGUI, and INI

Attachment not found

Please Log in to join the conversation.

Time to create page: 0.043 seconds