Another plasma component...

  • thefabricator03
  • New Member
  • New Member
More
7 years 2 months ago #142695 by thefabricator03
Replied by thefabricator03 on topic Another plasma component...
With the air scribe,

I cannot find setp plasmac.multi-tool 0 in my <MACHINE_NAME>_connections.hal.

I have posted the file to this post.

Please Log in to join the conversation.

More
7 years 2 months ago #142696 by Dee436
Replied by Dee436 on topic Another plasma component...

phillc54 wrote: Darren,

In hindsight, I think this issue is why you had to set SPINDLES = 1 in the TRAJ section of the HAL file and had problems with the air-scribe part of connections.hal


Hi Phill

I will make the hostmot edit and change the spindles back to 2 and see what happens

Thanks
Darren

Please Log in to join the conversation.

More
7 years 2 months ago #142697 by phillc54
Replied by phillc54 on topic Another plasma component...
Sorry Guys,

It looks like the issue is causing the Configurator to quit without finishing and causing a bit of havoc...

Try these files Stefan.

Please Log in to join the conversation.

  • thefabricator03
  • New Member
  • New Member
More
7 years 2 months ago #142698 by thefabricator03
Replied by thefabricator03 on topic Another plasma component...

phillc54 wrote:
Which button do you want to change to the Pierce option?


The load sheet button, I have never used it.

Please Log in to join the conversation.

More
7 years 2 months ago #142699 by phillc54
Replied by phillc54 on topic Another plasma component...
Try this...

Please Log in to join the conversation.

  • thefabricator03
  • New Member
  • New Member
More
7 years 2 months ago #142701 by thefabricator03
Replied by thefabricator03 on topic Another plasma component...
That worked now just getting the tool table setup

Please Log in to join the conversation.

  • thefabricator03
  • New Member
  • New Member
More
7 years 2 months ago #142702 by thefabricator03
Replied by thefabricator03 on topic Another plasma component...
Ok with the scribe,

The sheetcam file you sent me, The torch is being used when I have run the code instead of the scribe.

If I manually run M3 $1 S0, I can not longer jog the machine but then when I run the program the machine starts moving again and the torch goes to cut out the scribed part.

Please Log in to join the conversation.

  • thefabricator03
  • New Member
  • New Member
More
7 years 2 months ago #142703 by thefabricator03
Replied by thefabricator03 on topic Another plasma component...

phillc54 wrote: Try this...


Its not changing the program when I press the button to pierce only.

Please Log in to join the conversation.

More
7 years 2 months ago #142704 by phillc54
Replied by phillc54 on topic Another plasma component...
YES, that is from the temporary fix I pushed yesterday morning. I am almost done and will push an update that should fix everything soon.

Please Log in to join the conversation.

More
7 years 2 months ago #142706 by phillc54
Replied by phillc54 on topic Another plasma component...
I have pushed an update which should fix all the latest issues that I caused.

Edit: I haven't done any docs for the Pierce Only mode yet.

Edit 2: Now I have ...

I also have the user guide in PDF format for downloading.

Please Log in to join the conversation.

Time to create page: 0.202 seconds
Powered by Kunena Forum