Another plasma component...

More
6 years 8 months ago #157493 by phillc54
Replied by phillc54 on topic Another plasma component...
[strike]Does this happen for all axes?

Is it when touching off to Zero or to a specific value or both?

What locale do you use?[/strike]

It is something to do with locales, I can duplicate it here.

Please Log in to join the conversation.

More
6 years 8 months ago #157502 by phillc54
Replied by phillc54 on topic Another plasma component...
OK, this is a combination of a couple of errors.
  1. I didn't allow locale translation for a couple of buttons
  2. There was an error in the recent German translation updates
I have just pushed the fixes.

Please Log in to join the conversation.

More
6 years 5 months ago #168579 by Franklin
Replied by Franklin on topic Another plasma component...
Hi, I have not updated the plasmac for a long time, and now after update the spotting does not work , plasmaс repeats attempts in one place and does not move to the next position.
There was already such error, I wrote about it on page 171 .
Before updating this worked fine.
Can you try my file on your machine?
Thanks.

Please Log in to join the conversation.

More
6 years 5 months ago #168581 by Uthayne
Replied by Uthayne on topic Another plasma component...
I had this same issue and it was fixed for me by using the Rev E plasmac sheetcam pp

Please Log in to join the conversation.

More
6 years 5 months ago #168616 by phillc54
Replied by phillc54 on topic Another plasma component...
LinuxCNC changed the spindle on/off commands so where you have M5 you need to change it to either M5 $2 or M5 $-1

linuxcnc.org/docs/2.8/html/gcode/m-code.html#mcode:m3-m4-m5

Please Log in to join the conversation.

More
4 years 8 months ago #234211 by Aldenflorio
Replied by Aldenflorio on topic Another plasma component...
Okay, so with a plasma table that uses the mesa7i76 and the thcad10 which do I use? I have a floating head with a switch

Please Log in to join the conversation.

More
4 years 8 months ago #234273 by Aldenflorio
Replied by Aldenflorio on topic Another plasma component...
Sorry all of these comments confuse me a lot

Please Log in to join the conversation.

More
4 years 8 months ago #234300 by phillc54
Replied by phillc54 on topic Another plasma component...

Okay, so with a plasma table that uses the mesa7i76 and the thcad10 which do I use? I have a floating head with a switch
I don't understand the question.

Please Log in to join the conversation.

More
4 years 8 months ago #234301 by Aldenflorio
Replied by Aldenflorio on topic Another plasma component...
Which configuration do I use? For my last build I had the proma150 thc to which I used plasmac to set it up. Do I still instal plasmac and just configure it to the THCAD-10? Or are all these files outdated?

Please Log in to join the conversation.

More
4 years 8 months ago #234303 by phillc54
Replied by phillc54 on topic Another plasma component...
You should be able to modify an existing config by using the configurator in "Reconfigure" mode.

linuxcnc.org/docs/2.8/html/plasma/plasma...e.html#modify-config

Of course make a backup of your config beforehand.

Please Log in to join the conversation.

Time to create page: 0.190 seconds
Powered by Kunena Forum